Parts

Delivery time shipment Dixerparts

Active filters

Flasher Booster
Quick view

Flasher Booster

39 €
Availability: 20 In Stock
The Flasherbooster is connected between original flasher relay and your aftermarket indicators. It increase the supply voltages from the original flasher relay to 12 Volt and allow you to use your choice of aftermarket flashers at your bike. An integrated loadequalizer with 0,8 Watt load takes care for the correct flasher frequency in the most bikes.
Marker Light X
Quick view

Marker Light X

43 €
Availability: 10 In Stock
You can also remove the marker light function of the BCM module if you wire the Marker Light X between BCM module and the indicators. This eliminate the marker light function of the indicators.
Vari Load
Quick view

Vari Load

82 €
Availability: 7 In Stock
The solution is a digital adjustable load-equalizer with 50 different presets. The Vari Load is connected to your flashers. The load is adjustable via a simple "programming" cable.
Brake 2 Flash
Quick view

Brake 2 Flash

37 €
Availability: 4 In Stock
The programming of a flasher mode is easy and will cost you about 30 seconds without the need to be a software specialist.
Speed 2 Brake
Quick view

Speed 2 Brake

37 €
Availability: 3 In Stock
The Speed 2 Brake is an electronic brakeswitch what hang parallel to one of the original brakeswitches. The Speed 2 Brake have a speed sensor input what check a reduced speed and activate the brake light in case of a negative acceleration. The sensitivity is adjustable by 10 steps.
Rear Light EU
Quick view

Rear Light EU

108 €
Availability: 10 In Stock
The Rear Light EU is a module for bikes with emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A conversion of an US bike according to the requirements in the EU is much easier and less cost intensive with this new module.
Rear Light EU-V
Quick view

Rear Light EU-V

142 €
Availability: 10 In Stock
The Rear Light EU-V is a module for vintage bikes w/o emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A brakelight dim function can be activated.
Rear Light US
Quick view

Rear Light US

108 €
Availability: 5 In Stock
Almost every bike what runs in US have a brake light / indicator combination in the way, that 2 lamps works as brake light and as indicator as well. This makes a conversion of an imported bike from Europe according to the requirements in the US a bit tricky. A conversion of an EU bike according to the requirements in the US is much easier and less cost intensive with the Rear Light US.
Easy Keyless RFID
Quick view

Easy Keyless RFID

201 €
Availability: 10 In Stock
The activation of the module is made via a press on a button. Now you have 15 seconds time to put your rfid tag in front of the antenna. A red led on the antenna indicate the waiting state of the module. If the rfid tag is recognized then the led changes to blue color and the power for the bike is switching on. If the rfid tag is not recognized then the module fall back in sleep mode.
Micro Speedo Black
Quick view

Micro Speedo Black

125 €
Availability: 10 In Stock
The speedometer is very easy to use: If the button is pressed and held down when the power supply is switched on, the wheel circumference appears on the display in cm and counts up between 50 cm and 220 cm until the button is released. The 4 LEDs on the outside indicate neutral, high beam, indicators and oil pressure.
Micro Speedo Module
Quick view

Micro Speedo Module

52 €
Availability: 10 In Stock
The speedometer is very easy to use: If the button is pressed and held down when the power supply is switched on, the wheel circumference appears on the display in cm and counts up between 50 cm and 220 cm until the button is released. The 4 LEDs on the outside indicate neutral, high beam, indicators and oil pressure.