Speed 2 Brake

37 €
The Speed 2 Brake is an electronic brakeswitch what hang parallel to one of the original brakeswitches. The Speed 2 Brake have a speed sensor input what check a reduced speed and activate the brake light in case of a negative acceleration. The sensitivity is adjustable by 10 steps.
Quantity
Last items in stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

Speed 2 Brake

The most bikes with bigger engines have a good negative acceleration when reducing the throttle what result in no need to use a brakeswitch. In this case is no brake switch activated and the following traffic can not see that the speed of the bike is reduced what could cause in dangerous situations.

The Speed 2 Brake is an electronic brakeswitch what hang parallel to one of the original brakeswitches. The Speed 2 Brake have a speed sensor input what check a reduced speed and activate the brake light in case of a negative acceleration. The sensitivity is adjustable by 10 steps.

Maximum ambience temperature: 80 degree Celsius

DP9818
3 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
5 mm
5 mm
40 mm x 25 mm x 12
40 mm x 25 mm x 12
Input voltage range
7 - 18 Volt
Maximum temperature
80°C
80°C
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Sensitivity steps
10

16 other products in the same category:

Rear Light EU

108 €
Availability: 10 In Stock
The Rear Light EU is a module for bikes with emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A conversion of an US bike according to the requirements in the EU is much easier and less cost intensive with this new module.

Mini Headlight Relay

44 €
Availability: 10 In Stock
You can use the module with a permanent switch if you wire the yellow cable to ground. The module works with a push button if the yellow cable is not connected. By the way, you can switch off the headlight in the button mode when you press the button for more than 2 seconds. A further press on the button switch on the headlight again.