Automatyczny Przełącznik Świateł Dziennych (DRS)

54 €
Automatyczny przełącznik świateł dziennych z czujnikiem natężenia oświetlenia. Przełącza między światłem dziennym a mijania w zależności od warunków oświetleniowych.
Quantity
Last items in stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

Automatyczny Przełącznik Świateł Dziennych (DRS)

Ten elektroniczny przekaźnik zawiera 2 wyjścia zasilające po 60 W każde. Czujnik światła dziennego wykrywa, czy otoczenie jest ciemne czy jasne, i automatycznie przełącza między światłem dziennym a światłem mijania. Czas przełączenia ze światła dziennego na mijania jest natychmiastowy. Czas przełączenia z powrotem na światło dzienne wynosi 3 sekundy, aby uniknąć przypadkowych przełączeń przy odblaskach. Próg czułości czujnika można ustawić w 60 krokach.

Wymiary: 38 mm x 16 mm x 11 mm
Napięcie zasilania: 6–18 V
Maksymalna moc wyjściowa: 60 W / wyjście

AUTOMATIC_DAYTIME_RUNNINGLIGHT_SWITCH
2 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
38 mm x 16 mm x 11 mm
Body material
Black ABS plastic
waterresist potted
Input voltage range
6 - 18 Volt
Maximum output power
60 Watt / output

16 other products in the same category:

Rear Light EU

108 €
Availability: 10 In Stock
The Rear Light EU is a module for bikes with emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A conversion of an US bike according to the requirements in the EU is much easier and less cost intensive with this new module.

B-Box

180 €
Availability: 10 In Stock
- Switch - output for parking light / Plate light / speedo etc.

Evo Flasher 1

69 €
Availability: 10 In Stock
An auto-cancel function is integrated into the module. The corresponding output flashes 4 times when a turn signal button is pressed briefly for less than 0.5 seconds and then switches off. This function can be used for overtaking. If the button is pressed for longer than 0.5 seconds, the output flashes 40 times. The auto-cancel function can be deactivated by connecting the green wire to ground.

D-Box

167 €
Availability: 15 In Stock
- Integrated flasher relay, contol with buttons or switches

Micro Speedo Polished

125 €
Availability: 10 In Stock
The speedometer is very easy to use: If the button is pressed and held down when the power supply is switched on, the wheel circumference appears on the display in cm and counts up between 50 cm and 220 cm until the button is released. The 4 LEDs on the outside indicate neutral, high beam, indicators and oil pressure.