Marker Light X
    Marker Light X

Marker Light X

43 €
You can also remove the marker light function of the BCM module if you wire the Marker Light X between BCM module and the indicators. This eliminate the marker light function of the indicators.
Quantity
In stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

Marker Light X

The contrast of the direction indicators is often very low in combinations with marker lights due to the brightness of the marker lights. Our Marker Light X module switch off an external marker light in the moment when you switch on the direction indicators at one side. This increase the contrast of the indicators and they are easier to recognize from the other traffic.

You can also remove the marker light function of the BCM module if you wire the Marker Light X between BCM module and the indicators. This eliminate the marker light function of the indicators.

An other option is the a low light function what the Marker Light X can add to your installed flasher system if you wire the Marker Light X between flasher relay and indicators and wire the yellow cable to ground. The brightness of the indicators can be set to 20 % or 50 % of the maximum brightness if the flasher relay is not activated.

Maximum output power: 60 Watt / output

DP9814
10 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
38 mm x 16 mm x 11 mm
38 mm x 16 mm x 11 mm
Input voltage range
7 - 18 Volt
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Maximum output power
60 Watt / output

16 other products in the same category:

C-BS Harness
Quick view

C-BS Harness

299 €
Availability: 6 In Stock
The digital harness C-BS ("BS" stands for switches and buttons) for the bike control via push buttons and switches is an universal harness, what contain 2 small control boxes. The control boxes "talk" together via a thin serial bus cable. The switches, push buttons and power cables are wired direct to the nearest box. This reduces the amount of cables and the installation time significant in a typ
Rear Light US
Quick view

Rear Light US

108 €
Availability: 5 In Stock
Almost every bike what runs in US have a brake light / indicator combination in the way, that 2 lamps works as brake light and as indicator as well. This makes a conversion of an imported bike from Europe according to the requirements in the US a bit tricky. A conversion of an EU bike according to the requirements in the US is much easier and less cost intensive with the Rear Light US.
Rear Light EU-V
Quick view

Rear Light EU-V

142 €
Availability: 10 In Stock
The Rear Light EU-V is a module for vintage bikes w/o emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A brakelight dim function can be activated.
Overvoltage Indicator
Quick view

Overvoltage Indicator

43 €
Availability: 10 In Stock
As soon as an on-board voltage of 15.1 volts is exceeded for longer than 2 seconds, a warning flasher function is activated via the two blinker outputs and the additional LED output is switched on. In most cases, it is then sufficient to switch off the engine immediately to prevent major damage.
Flasher Booster
Quick view

Flasher Booster

39 €
Availability: 20 In Stock
The Flasherbooster is connected between original flasher relay and your aftermarket indicators. It increase the supply voltages from the original flasher relay to 12 Volt and allow you to use your choice of aftermarket flashers at your bike. An integrated loadequalizer with 0,8 Watt load takes care for the correct flasher frequency in the most bikes.
B-Box
Quick view

B-Box

180 €
Availability: 10 In Stock
Elektronicbox wersja B - moduł sterujący z łatwym montażem mechanicznym. Współpracuje ze standardowym wyłącznikiem zapłonu. 15-amperowy bezpiecznik szeregowy w linii zasilania.
Flasher Checker
Quick view

Flasher Checker

72 €
Availability: 10 In Stock
If an indicator fails in subsequent operation, i.e. the current consumed falls below 20% of the normal operating current, the Flasher Checker activates the hazard warning function for as long as the flasher relay is activated. The hazard warning function switches off automatically when the flasher relay is deactivated.