K Neutral

42 €
Dimensions: 38 mm length x 16 mm wide x 11 mm height
Quantity
In stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

K Neutral - Neutral Indicator for BMW K-Models

The K Neutral module is an indicator for the 3 gear switches in a BMW K bike. It have with a power output for the starter relay and the neutral indicator led. This module allow the indication of the neutral gear on every new standard speedo. It also enable the start relay without the need to pull the clutch for starting your bike.

Input voltage range: 6 - 18 Volt

DP9853
11 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
38 mm x 16 mm x 11 mm
38 mm x 16 mm x 11 mm
Body material
ABS plastic
waterresist potted
Input voltage range
6 - 18 Volt
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Compatible with
BMW K-models

16 other products in the same category:

B-Box

180 €
Availability: 8 In Stock
- Switch - output for parking light / Plate light / speedo etc.

Micro Speedo Black

125 €
Availability: 10 In Stock
The speedometer is very easy to use: If the button is pressed and held down when the power supply is switched on, the wheel circumference appears on the display in cm and counts up between 50 cm and 220 cm until the button is released. The 4 LEDs on the outside indicate neutral, high beam, indicators and oil pressure.

Rear Light EU-V

142 €
Availability: 10 In Stock
The Rear Light EU-V is a module for vintage bikes w/o emergency flasher function. It converts the two signals from the original flasher / brake light combination in four separate outputs for brake light / rear light and indicators. A brakelight dim function can be activated.

Overvoltage Indicator

43 €
Availability: 10 In Stock
As soon as an on-board voltage of 15.1 volts is exceeded for longer than 2 seconds, a warning flasher function is activated via the two blinker outputs and the additional LED output is switched on. In most cases, it is then sufficient to switch off the engine immediately to prevent major damage.

Evo Flasher 1

69 €
Availability: 10 In Stock
An auto-cancel function is integrated into the module. The corresponding output flashes 4 times when a turn signal button is pressed briefly for less than 0.5 seconds and then switches off. This function can be used for overtaking. If the button is pressed for longer than 0.5 seconds, the output flashes 40 times. The auto-cancel function can be deactivated by connecting the green wire to ground.

E-Harness

460 €
Availability: 3 In Stock
The E-Harness contain a dashboard control module and 2 power modules what control the 12 Volt power to all lights and other 12 Volt devices in a car. All switches and buttons at the dashboard are connected to the dashboard module. The modules "talk" via a small 2-wire data line. Almost all power outputs are short circuit protected and self resetting after the short circuit.