Multi Flasher Plus
    Multi Flasher Plus

Multi Flasher Plus

43 €
Dimensions: 38 mm x 16 mm x 11 mm
Quantity
In stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

Multi Flasher Plus

This is a small flasher controller for pushbuttons in a small package what will fit in every handlebar. This device is controlled via 12 Volt inputs, what make it easier to implement in an existing OEM harness if no minimal wiring is required. An auto cancel function can be activated. It switch off the indicators after a while if no button is be pushed.

DP9808
20 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
38 mm x 16 mm x 11 mm
38 mm x 16 mm x 11 mm
Body material
ABS with 2k epoxy resin potted
Input voltage range
7 - 18 Volt
Maximum temperature
80°C
80°C
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Maximum output power
40 Watt / output

16 other products in the same category:

Micro Speedo Module
Quick view

Micro Speedo Module

52 €
Availability: 10 In Stock
The speedometer is very easy to use: If the button is pressed and held down when the power supply is switched on, the wheel circumference appears on the display in cm and counts up between 50 cm and 220 cm until the button is released. The 4 LEDs on the outside indicate neutral, high beam, indicators and oil pressure.
E-Harness
Quick view

E-Harness

460 €
Availability: 3 In Stock
The E-Harness contain a dashboard control module and 2 power modules what control the 12 Volt power to all lights and other 12 Volt devices in a car. All switches and buttons at the dashboard are connected to the dashboard module. The modules "talk" via a small 2-wire data line. Almost all power outputs are short circuit protected and self resetting after the short circuit.
Brake 2 Flash
Quick view

Brake 2 Flash

37 €
Availability: 4 In Stock
The programming of a flasher mode is easy and will cost you about 30 seconds without the need to be a software specialist.
Flasher Booster
Quick view

Flasher Booster

39 €
Availability: 20 In Stock
The Flasherbooster is connected between original flasher relay and your aftermarket indicators. It increase the supply voltages from the original flasher relay to 12 Volt and allow you to use your choice of aftermarket flashers at your bike. An integrated loadequalizer with 0,8 Watt load takes care for the correct flasher frequency in the most bikes.
C-BS Harness
Quick view

C-BS Harness

299 €
Availability: 6 In Stock
The digital harness C-BS ("BS" stands for switches and buttons) for the bike control via push buttons and switches is an universal harness, what contain 2 small control boxes. The control boxes "talk" together via a thin serial bus cable. The switches, push buttons and power cables are wired direct to the nearest box. This reduces the amount of cables and the installation time significant in a typ
Speed 2 Brake
Quick view

Speed 2 Brake

37 €
Availability: 3 In Stock
The Speed 2 Brake is an electronic brakeswitch what hang parallel to one of the original brakeswitches. The Speed 2 Brake have a speed sensor input what check a reduced speed and activate the brake light in case of a negative acceleration. The sensitivity is adjustable by 10 steps.