Air Ride Control

95 €
- Press the button and switch on the ignition. The pump will start immediately.
Quantity
In stock

 

Safe shopping

  Types of deliveries and payments:

[see details]

  Complaints and returns:

[see details]

available payment methods

Guarantee safe & secure checkout

Delivery time shipment

Air Ride Control

This Air Ride memory unit save and recall the pump up time and the valve open time. It allow the user to save and recall individual heights of your bike. The 2 outputs can drive loads with a power of up to 350 Watt peak and 200 Watt continous. The individual height can set and store via the following procedure:

  • Press the button and switch on the ignition. The pump will start immediately.
  • Hold the button until your bike have the preferred height.
  • Release the button and press it again until the bike is in the lowest position. That's it.

The Air Ride Control switch on the pump the next time and recall the adjusted height when you switch on the ignition and it open the valve when you switch off the ignition.

DP9835
10 Items

Data sheet

Manufacturer
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Dimensions
5 mm
5 mm
40 mm x 25 mm x 12
40 mm x 25 mm x 12
Input voltage range
7 - 18 Volt
Producent
27404 Rhade
Axel Joost Elektronik
Dipl.-Ing. Axel Joost
Germany
Selsinger Str. 28
Maximum power peak
350 Watt
Maximum power continuous
200 Watt

16 other products in the same category:

Mini Headlight Relay

44 €
Availability: 10 In Stock
You can use the module with a permanent switch if you wire the yellow cable to ground. The module works with a push button if the yellow cable is not connected. By the way, you can switch off the headlight in the button mode when you press the button for more than 2 seconds. A further press on the button switch on the headlight again.

Fusebox

125 €
Availability: 10 In Stock
This fuse box contains 6 separate outputs which switch off in the event of a short circuit and switch on again after the short circuit has been eliminated. 4 of the outputs have continuous positive and 2 outputs can be switched on or off via 2 buttons. This can be used to switch additional headlights, cell phone chargers, etc. In addition, the supply voltage is monitored and the outputs in the mod